Grid-Tied Residential Inverters
Installation and Operation Manual
5
3. INST
ALLA
TION
3. Installation
3.1 Mounting and Anchoring
Models PVP4600, PVP4800 and PVP5200
Locate the wall studs in the desired location and align the mounting bracket over the
1.
studs. Mark the mounting holes. Ensure that locations A and B (see Figure 3-1) are
aligned over the wall studs.
VERIFY THE BRACKET IS LEVEL.
2.
Ensure points A and B are aligned with the wall
studs. Drill 1/8” pilot holes for the screws.
Use heavy-duty 1/4 inch x 2 inch coarse thread lag screws to secure points A and
B to the wall.
Use an 1/8” screw to secure point C (see Figure 3-1).
A
B
C
Figure 3-1 V-shaped Mounting Bracket
Carefully hang the inverter on the upper part of the bracket. The hooks located at the
3.
rear of the inverter should hang over the bracket.
Verify inverter is level.
4.
For the PVP4600, PVP4800, or PVP5200 models, remove the four screws on the lower
5.
lid to access the electrical connections.
There are no user serviceable parts in the upper portion of the inverter.
Locate the two inverter mounting holes below the power board (see Figure 3-2).
6.
Insert the two mounting screws through the inverter and tighten securely.
Содержание 1100
Страница 37: ...30 Notes ...
Страница 41: ...34 ...
Страница 42: ...150 SW Scalehouse Loop U Bend OR 97702 U P 541 312 3832 U www pvpowered com ...
