PURSUIT 3070 Conter Console, Руководство пользователя

Страница: 49 / 126

C 300
49
CERTAIN BULKHEAD AREAS ARE SEALED IN ACCORDANCE WITH U.S. COAST GUARD
REGULATIONS THAT WERE IN EFFECT AT THE DATE OF MANUFACTURE OF THE
BOAT. ANY MODIFICATIONS TO THESE BULKHEADS SHOULD BE IN ACCORDANCE
WITH THE U.S. COAST GUARD REGULATIONS.
FISHBOX
The fishbox below the cockpit floor is drained overboard by a macerator pump-out system. The macerator
is activated by a momentary switch located in a switch panel in the cockpit below the gunwale. The fishboxes
should be flushed out and cleaned after each use. The macerator discharge pump can only be run dry for a
few seconds. Allowing the macerator pump to run after the fishbox is empty may cause damage to the pump.
LIVEWELL DRAINS
The livewell drains by gravity to overboard thru-hulls located in the hull sides just above the waterline. The
overflows in the livewell also drain into the overboard drains.
ROPE LOCKER DRAINS
The rope locker drains overboard through a special drain fitting located in the hull side at the bottom of the
rope locker. It is important to inspect the drain frequently to remove any accumulated debris.
HEAD COMPARTMENT DRAINS
The head sink drains by gravity to a sump pump. The sump system is located in the bilge and accessed through
a hatch in the head compartment. An automatic float switch in the sump controls the pump. The pump is
protected by the sump pump circuit breaker in the cabin DC panel. The sump has a removable hatch to allow
the system to be inspected and serviced. It is essential that the sump system be inspected periodically and any
accumulated debris removed.
The drain thru-hull fitting for the sump pump is equipped with a ball valve that is always open under normal
operating conditions. In the event of an emergency, the valve can be closed to prevent seawater from entering
the boat through the shower sump system. The drain valve for the sump pump is located on the port side of
the center bilge compartment. It is important to check and operate the valves at least annually to make sure
they are in good condition and operating properly. Please review the drainage schematic to become familiar
with the location of the sump pump and gravity drain thru-hull valves.
5.5 Plumbing Systems Maintenance
WATER SYSTEMS
Information supplied with water system components, by the equipment manufacturers, is included with this
manual. Refer to this information for additional operation and service data.
The following items should be done routinely to maintain your fresh water system:
• Remove the filter screens from the faucet spouts and eliminate any accumulation of debris. A build-up
of debris can cause the pump to cycle excessively.
• The fresh water system is equipped with a strainer located on the intake line near the pump. This should
be checked at least annually and cleaned as necessary.
• Periodically spray the pumps and metal components with a metal protector.
NOTICE