PURSUIT 3070 Conter Console, Руководство пользователя, Страница: 39 / 126

C 300
39
Interior Lights
Supplies 12-volt electrical current to the cabin light switches.
Head Macerator
Supplies electrical current to the switch, that controls the macerator overboard discharge pump for the holding
tank. This breaker should be in the “OFF” position except when pumping out the holding tank.
Electronics Main
Reserved for electronics installations.
Fresh Water System
Supplies 12-volt electrical current directly to the fresh water pump pressure switch located on the pump. The
pump is the pressure demand type and is protected by a circuit breaker in the panel and an automatically
resetting breaker on the pump motor. The pressure switch automatically controls the water pump when the
system is activated and properly primed.
Accessory
Reserved for future use.
Helm Seats
Supplies 12-volt electrical current to the leaning post control switches located in the front of the leaning post
next to each seat.
HEAD COMPARTMENT PANEL
Holding Tank Macerator
The holding tank overboard discharge macerator switch panel is located in the head compartment next to the
holding tank monitor. It is a momentary switch that activates the overboard macerator discharge system for
the holding tank. Refer to the Marine Head System in the Interior Equipment chapter for additional
information on the operation of the overboard macerator discharge system.
Holding Tank Level
The panel contains the holding tank level indicator that indicates the level of the holding tank. Refer to the
head system owner's manual for more information on this system.
12-VOLT RECEPTACLE
Provides electrical current for portable 12-volt equipment.
4.5 AC System (Optional)
The AC system is fed by the shore power outlet. It is equipped with an on-board
galvanic isolation. The galvanic isolator is equipped with a system status monitor.
Refer to the galvanic isolator owner's manual. All AC current is distributed to the AC
accessories through individual circuit breakers located in the AC panel. The main
breaker in the panel protects the system from an overload and the reverse polarity light
indicates any problems due to an improper shore power supply. All AC outlets are
protected by ground fault interrupters to protect against electrical shock. A cord set
is provided to supply power from the shore power outlet to the boat’s AC shore power inlet.
Shore Power Inlet