PURSUIT 3070 Conter Console, Руководство пользователя, Страница: 36 / 126

C 300
36
Mid Bilge
Supplies 12-volt electrical current to the sump pump that is connected to the sink and shower drains. This
is a "push to reset" breaker that is normally on all the time unless tripped by an overload. Make sure this breaker
is on before using the cabin shower.
Windlass (Optional)
Push the red button to open the circuit breaker. To reset or turn the circuit breaker on, rotate the black lever
to the "ON" position. Turning off this breaker when the windlass is not in use will reduce the possibility of
accidentally activating the windlass.
Engine Circuit Breakers
Circuit protection for the ignition switch and engine components is provided on the engine. Please refer to
the engine owner's manual for information on the circuit breakers installed on your engines.
4.4 12-Volt DC Panels
HELM BREAKER PANEL
The helm and cockpit switch functions are protected by a breaker panel located below the steering helm. The
breaker panel is equipped with "push to reset" breakers that are protected from the elements by rubber boots.
These breakers are all normally on and cannot be manually turned off. Should one of these breakers trip from
overload, push the breaker plunger inside the boot to reset.
The following are descriptions of the accessories controlled by the main accessory switch panel:
HELM SWITCH PANELS
UPPER PANEL
Cockpit Lights
Activates the lights that illuminate the cockpit area.
Nav/Anchor Lights
The switch is a three-position switch. The middle position
is “OFF.” Depressing the top of the switch activates the
navigation lights. Depressing the bottom on the switch
activates the anchor light.
Spreader Lights
Activates the flood lights located on the optional T-top. These lights provide additional lighting for the rear
of the cockpit.
Helm Breaker Panel
Upper Helm Switch Panel (Typical)