PURSUIT 2460 Denali, Руководство пользователя

Страница: 69 / 132

2460 Denali
Chapter: 10
INTERIOR EQUIPMENT
10.1 Marine Head System
Marine Head System
This system is provided as standard equipment. The flush water is supplied
by a thru-hull fitting and a raw water line. Before using, open the inlet valve
on the head and pump to wet the inside of the bowl. After use, close the
valve and pump to discharge the waste to the holding tank. An electric china
head is optional.
Waste is pumped into the holding tank where it remains until it is pumped
out by a waste dumping station or the optional overboard macerator
discharge system.
Holding Tank and Macerator Discharge Pump
The holding tank is located in the bilge. When the tank is full
it must either be pumped out by an approved waste dumping
station through the waste deck fitting or be pumped over-
board with the macerator discharge pump, when legal to do
so.
To operate the macerator discharge pump, open the dis-
charge ball valve located in the engine compartment. Then
activate the macerator switch, located in the engine compart-
ment, until the tank is emptied, and release the switch.
THE MACERATOR DISCHARGE PUMP CAN ONLY BE RUN DRY FOR A
FEW OF SECONDS. ALLOWING THE MACERATOR PUMP TO RUN AF-
TER THE HOLDING TANK IS EMPTY MAY CAUSE DAMAGE TO THE
PUMP.
IN SOME WATERS YOU CAN BE FINED FOR HAVING AN OPERABLE DI-
RECT OVERBOARD DISCHARGE OF WASTE. TO AVOID A FINE, REMOV-
ING THE SEACOCK HANDLE, IN THE CLOSED POSITION, OR OTHER
MEANS MUST BE USED.
10-1
Marine Head
NOTICE
Macerator Switch