PURSUIT 2460 Denali, Руководство пользователя

Страница: 63 / 132

2460 Denali
DO NOT USE A WINDLASS AS A SOLE MEANS OF SECURING AN ANCHOR IN THE BOW
ROLLER. ALWAYS SECURE THE ANCHOR LINE TO A CLEAT OR ANCHOR CLASP BE-
FORE OPERATING YOUR BOAT.
Bimini Top and Side Curtains
The canvas for Pursuit boats is custom fit to each boat. The bimini top is designed with a relatively
flat profile and a snug fit. The canvas is fit to the boat at the factory and the bimini top must be
installed properly in order for the clear connector and side curtains to fit.
To install the Bimini top, attach the main legs to the deck hinges using the quick release pins and
leave the rear stanchions loose. Next, open the bimini and attach the front straps to the metal eye
straps on the top of the windshield frame. Attach the rear stanchions, one at a time, to the rear deck
hinges located near the rear of the windshield. Use your body weight on the rear corner of the bimini
to pull down and stretch the fabric until the stanchion eye end lines up with the hole in the deck
hinge. Secure each eye end to the deck hinge with the quick release pins. If the top is still adjusted
to factory specifications, the top will be level and the main legs will have a visible bow in them.
Note: The front straps of the bimini must be secured to the windshield before the rear
stanchions are secured to the deck. If the rear stanchions are secured first, it will be
very difficult to secure the front straps without loosening them. If the front straps are
loosened, the bimini top will be too loose and the clear connector and side curtains will
not fit properly and appear to be too short.
Attach the clear connector to the zipper at the front of the top and snap it to the top of the windshield
frame beginning with the center snaps. If the bimini top is adjusted properly, the clear connector
will have to be stretched just enough to pull out the wrinkles and reach the snaps on the windshield.
The front straps will continue to bear the main load of the top.
Once the clear connector is completely installed, the side curtains can be put on. Attach the side
curtains to the zippers on the sides of the bimini and to the front connector. Snap the curtains to
the windshield and the deck beginning with the forward snaps on the windshield. If the bimini is
adjusted properly, the side curtains will have to be stretched slightly to pull out the wrinkles and
reach the snaps. The main load for the top should remain on the front straps and the rear stanchions.
Attach the drop curtain to the zipper on the back of the bimini and to the side curtains. Snap the
curtain to the deck and cockpit.
If you have an aft curtain, it is installed by attaching it to the zipper on the back of the bimini and
to the side curtains. Then snap the curtain to the deck beginning with the front snaps and work
towards the stern.
9-3