PURSUIT 2460 Denali, Руководство пользователя

Страница: 106 / 132

2460 Denali
14.2 Winterizing
Freshwater System
The entire freshwater system must be completely drained. Disconnect all hoses, check valves, etc.
and blow all the water from the system. Make sure the freshwater tank is completely drained. Use
only very low air pressure when doing this to prevent possible system damage. Because of the
check valve mechanism built in the pump, blowing the lines will not remove the water from the
freshwater pump. Remove the inlet and outlet hoses on the pump. Turn the pump on and allow
it to pump out any remaining water....about a cupful. A recommended alternative to the above-
mentioned procedure is the use of commercially available non toxic, freshwater system antifreeze.
After draining the potable water tank and lines, pour the antifreeze mixture into the freshwater tank,
prime and operate the pump until the mixture flows from all freshwater faucets. Be sure to open
all freshwater faucets, including the freshwater spray head in the leaning post bait station sink.
Make sure antifreeze has flowed through all of the freshwater drains.
For additional information on the freshwater system refer to the Freshwater System chapter.
Raw Water System
Completely drain the raw water systems. Disconnect all hoses and blow the water from the system.
Use only very low air pressure when doing this to prevent possible system damage. Because of the
check valve mechanism built in the raw water washdown pump, blowing the lines will not remove
the water from that raw water pump. Remove the inlet and outlet hoses on the pump. Turn the pump
on and allow it to pump out any remaining water....about a cupful. A recommended alternative to
the above-mentioned procedure is the use of commercially available nontoxic, potable water
system antifreeze. If potable water antifreeze is used, pour the mixture into a pail and put the raw
water intake lines into the solution. Run the pumps one at a time until the antifreeze solution is
visible at all raw water faucets and discharge fittings and drains. Be sure antifreeze has flowed
through all of the raw water drains.
Drain all of the sea strainers and raw water supply and discharge lines for the engine raw water
supply pump. Make sure all water has drained from the exhaust system. Once this is accomplished
please follow the engine manufacturer’s winterizing procedures located in your engine owner’s
manual or contact a Pursuit dealer.
Marine Toilet
The marine toilet must be properly winterized by following the manufacturer’s winterizing
instructions in the marine toilet owner’s manual. Drain the intake and discharge hoses completely
using low air pressure if necessary. The head holding tank must be pumped dry and one gallon of
potable water antifreeze poured into the tank through the deck waste pump out fitting.
Note: Make sure you follow the marine toilet manufacturer's winterizing instructions
exactly.
14-4