PureTools PT-IPAV-E2-RX, Руководство пользователя

Страница: 8 / 24

User Manual
PT-IPAV-E2
8
5.1.1 Setting the IP address
A). DHCP (Dynamic host configuration protocol)
If you are using a Switch that supports DHCP, please enable DHCP so that the Switch will assign an unique IP for TX
and RX, and you don’t need to change the IP for the units manually.
B). Set the IP via web browser
If you are using a Switch that doesn’t support DHCP, please change the default IP for TX (192.168.1.11) and RX
(192.168.1.12) manually.
A HTTP server is embedded in each TX and RX. You can set up IP address for HDMI Extender via web browser
The default IP address of the TX is 192.168.1.11, user name: admin, password: admin
The default IP address of the RX is 192.168.1.12
Operating Instructions
Step 1:
Make sure the Transmitter and PC are in the same domain.
Access the Network Setting Control Panel in Windows and locate your Lan connection. Under Windows 7, this
can be done by clicking Start > Control Panel > Network Sharing center > Change adapter settings > Properties
>Internet Protocol Version4 (TCP/IPv4). Change the IP address field to 192.168.1.1 (0-255). After that press „OK“
to save the configuration.
NOTE: The PC and TX/RX should be in the same domain.
The IP address of PC should be different from the IP address of TX and RX.
Step 2:
Use an Ethernet Cable to connect the PC (or laptop) and the extender. the power LED for the extender is red and
the green status is blinking.
Step 3:
Login in IE: 192.168.1.11 (default IP for TX) or 192.168.1.12(default IP for RX), You can setup IP address for the TX
and RX. TX requires user name: admin and password: admin
Please set IP address for each TX and each RX, IP: 192.168.1.XX (XX:1-255. all IP address for TX and RX must be
different and can’t be same as the PC’s address.)