16
Installation & Operation Manual
Copyright © Puretec Pty Ltd 2018
Maintenance Procedure
cont.
10. Slowly insert UV lamp into chamber through the hole of
the aluminium nut end. Connect the lamp connector to the
pins on the lamp. Do not let go of the lamp until the lamp is
connected to the socket.
Never touch the quartz (glass) and lamp surface as marks
or fingerprints may interfere with UV transmission. If lamp
is soiled, please clean lamp with an alcohol based cleaner.
11. Put safety cap on the aluminium nut end. Connect the
ground wire to the chamber. Plug in the ballast power
connector. Make sure that the GREEN LED is illuminated.
12. Restore water supply and check unit for leaks. Re-check the
unit after 1 hour.
Note: For initial use, wait 3-5 minutes to allow water to
pass through the whole unit. Turn on a downstream tap
to let the water flow through the unit for 2-3 minutes to
release any air and impurities from system.
13 Reset the lamp timer by pressing the mode button until an
audible “beep” sounds indicating that the lamp timer has
been reset for a further 12 months.
We recommend replacing UV lamp annually to ensure high
sterilizing rate with best water quality.
Always keep UV lamp on, as power fluctuation will shorten
the service life of the UV lamp.
Cleaning Quartz Sleeve
1
2
3
valve
IN
OUT
10
mins
4
5
6
Replacing UV Lamp
7
8
9
Replacing UV Lamp
valve
IN
OUT
1
2
3
4
5
O Ring
3
O Ring
Cleaning Quartz Sleeve
1
2
3
valve
IN
OUT
10
mins
4
5
6
Replacing UV Lamp
7
8
9
Replacing UV Lamp
valve
IN
OUT
1
2
3
4
5
O Ring
3
O Ring
Cleaning Quartz Sleeve
1
2
3
valve
IN
OUT
10
mins
4
5
6
Replacing UV Lamp
7
8
9
Replacing UV Lamp
valve
IN
OUT
1
2
3
4
5
O Ring
3
O Ring
Содержание HYBRID R10
Страница 20: ......
