SEAGULL
®
IV X-1F
Drinking Water Purification System
NOTE: Read instructions completely before starting.
General Ecology’s X-1F drinking water purification system is designed to operate at pressures ranging from 25 to 125 psi. If pressure
surges are a possibility (municipal water supplies), install a Pressure Regulator or Surge Protector on the cold water supply line. This
system is intended to be installed to the cold water supply line, downstream of and above the cold water shut-off valve inside the
kitchen sink cabinet (see page 4). Be sure to close supply valves before installation. The Connector Hose will fit an Owner-Supplied
Connector T or our optional Saddle T Assembly or Male Run T shown on page 4. Connector branch of Owner Supplied T must have
a
a
a
a
a
" Male Compression Thread (
h
h
h
h
h
" - 24 Thread). The cold water supply line should be clean and free of construction debris. A
p
p
p
p
p
" to
1½" diameter hole is necessary for mounting the easily installed special Faucet furnished with this unit.
Follow steps 1 through 9 for installation. Steps A through F are cartridge replacement instructions. An order blank is included for
assistance in obtaining replacement Cartridges. Configuration specifications are shown at the end of this guide.
Installation Instructions
INSTALLATION AND PRODUCT USE GUIDE
supersedes 200712Ax-1f-i&o
