Pulsar INTE, Инструкция

Страница: 6 / 20

www.pulsar.pl INTE
6
After restoring the factory settings of the router and the interface, the yellow LED of the
interface is on and the green LED is blinking, indicating active connection. If not, disconnecting and
reconnecting the power supply of the module might be necessary. If that does not help, restore the
factory settings of the router and the interface once again.
4.4 STEP 2 – The IP address configuration.
For proper IP address change, it is recommended to turn off the firewall of the antivirus
program for the time of configuration process.
Run the „Digi Device Discovery” program, with icon. After launching, the program will
display the Ethernet interface logged in to the router. Identification of the module can be done by
comparing the MAC addresses.
Fig. 3. Window of the „Digi Device Discovery” program showing a logged-in Ethernet interface.
The MAC address of the interface is located under the barcode of the DIGI module.
Fig. 4. The MAC address on the DIGI module.
In order to facilitate the further use of the devices in the network, change the IP address
assignment from automatic to manual. To do that, press the right mouse button on the line with the
selected interface and choose „Configure network settings” option.