Pulsar INTE, Инструкция

Страница: 12 / 20

www.pulsar.pl INTE
12
5.2 Configuration of power supplies of PSBEN series with LED display
The PSU is fitted with LED display, which enables setting the communication parameters of the
serial port from the LED panel. To enter the setup mode, simultaneously press the „<,>” rightmost and
leftmost buttons on the LED panel. Depending on the displayed information, the following parameters
can be set: „Adr” – the device address, „trS” – transmission speed, „trP” – transmission parameters.
– simultaneously press the „<,>” rightmost and leftmost buttons on the LED panel
- The „Adr” parameter will be displayed
- press the right arrow „>”
- The „trS” parameter will be displayed
- press „OK.”
- The display will show one of the two parameters: „9.6” or „19.2” informing
about the selected transmission speed
- use the „<” or „>” buttons in order to set the transmission speed to 19200,
displayed as „19.2”
- confirm by pressing „OK.”
- The „trS” parameter will be displayed again
- press the right arrow „>”
- press "OK" when „trP” is displayed
- The display will show one of the three parameters: „8n2”, „8E1” or „8o1”
- use the „<” or „>” buttons in order to set the „8E1” parameter
- confirm by pressing „OK.”
- Simultaneously press the „<,>” rightmost and leftmost buttons to complete
the configuration procedure