8.1. CORE as monocular.
Detailed description of the monocular
CORE
can be found in section
9 “OPERATION. CALIBRATION”.
OPERATION
8
BATTERY INSTALLATION
7
Turn the battery compartment knob
(6)
counterclockwise until stop and remove it.
Install two CR123A batteries according to the
marking on the battery compartment cover and
inside it.
Turn the battery compartment knob clockwise
until stop – the latch
es from both sides of the
cover
will pull out
(see the drawing).
Replace the battery cover and press it until its
clicking position -
make sure
the cover
is
close
d on both sides
.
Battery charge level is displayed on the status
bar (
).
In case of complete battery discharge, icon
is
flashing on the status bar.
Unit
CORE
can be used as a monocular or front attachment for day
device
.
Original design allows the monocular to be quickly converted into attachment
and vice versa.
Note: please do not use batteries of different types or batteries with
various charge levels.
8.2. CORE as front attachment.
CORE
as attachment is designed to use
a day device
both in the
nighttime and daytime in inclement weather (fog, smog, rain etc.).
To convert the monocular into attachment and to mount it on a
day device
,
please follow instructions as follows:
Stage 1. Mounting
attachment’s eyepiece
on CORE unit.
Rotate the eyepiece locking ring
(5)
counterclockwise until you hear a
click and remove the eyepiece
(Fig. 1)
.
Mount the
on the unit as follows:
attachment’s eyepiece
- Make sure that the salients
(A)
of the
are
attachment’s eyepiece
located above the lower salients
(see Fig.2)
.
- Locate the
so that the lock
(B)
is parallel to the
attachment’s eyepiece
Pulsar logo
(L)
on unit’s body (Fig.3).
- Insert the
into unit’s body until stop and secure
attachment’s eyepiece
it by turning the
b
(
7
)
clockwise.
ayonet-type ring
Before use make sure that you have mounted and adjusted the unit according
to the instructions of the section 8
“Operation”
.
Store with the lens cap on in the carrying case.
Switch off the unit after use.
Attempts to disassemble or repair the unit will void the warranty!
The unit is designed for use in various operating temperatures. However, if it
has been brought indoors from cold temperatures, do not turn it on for 2 to 3
hours. This will prevent external optical surfaces from condensation.
To ensure reliable performance, it is recommended to carry out regular
technical inspections of the unit.
WARNING! Do not point the objective lens of the unit at intense sources
of light such as the sun. This may disable electronic components of the
unit. The warranty does not cover damage caused by improper
operation.
GUIDELINES FOR OPERATION
6
The unit has been designed for long-term use. To ensure sustainable
performance, please adhere to the following:
Fig.1
Fig.2
Fig.3
correct
wrong
Open:
Close:
5
6
7
А
L
B
7
Warning:
do not use rechargeable batteries since their use causes
inaccurate battery level indication and and possible disconnection during
operation.
