Pulsar Measurement FlowCERT, Инструкция по эксплуатации

Страница: 92 / 143

FLOWCERT LITE (UL) INSTRUCTION MANUAL
92
The third parameter for each relay determines the assignment or
condition of the relay, where required.
P212, 222, 232, 242, 252 – Relay Alarm ID/Pump Group
P211, 221, 231, 241, 251 = 2 (Step Time)
If the relay is selected for Step Time, then this parameter is used to assign
the relay to the 0 =
Open condition (increase level) or 1 = Close condition
(decrease level).
The
fourth parameter , fifth parameter and sixth parameter are set to
determine the switch points, “ ON ” and “ OFF ” for the relay and where
required the order of start. See control function , table ( P211, 221, 231,
241, 251 ) for further information.
P213, 223, 233, 243, 253 – Relay Setpoint 1
P211, 221, 231, 241, 251 = 1 (Time)
This parameter determines the “Time Period” that the relay will remain “ON”.
Relay Setpoints are entered in Minutes. See the appropriate relay function
tables (P211, 221, 231, 241, 251) for further information.
P211, 2210, 231, 241, 251 = 2 (Step Time)
Relay Setpoint 1 is entered in values of Measurement Units (P104)
See the appropriate relay function tables (P211, 221, 231, 241, 251) for
further information.
P214, 224, 234, 244, 254 – Relay Setpoint 2
P211, 221, 231, 241, 251 = 1 (Time)
This parameter determines the “Cycle Time” for the opera tion of the relay.
See the appropriate relay function tables (P211, 221, 231, 241, 251) for
further information.
P211, 2210, 231, 241, 251 = 2 (Step Time)
Relay Setpoints are entered in Seconds to set Drive Period, the time that the
relay will remain
‘ ON ’.
See the appropriate relay Function tables (P211, 221, 231, 241, 251) for
further information.