BoardWalk Ramp and Platform Assembly Instructions
11
Identify the front edge of the section (the end with arms - opposite
from the end with sockets).
Drive one
pan head wood screw
(#12 x 1”)
(#A) in the middle
hole on the left hinge. Push the right knuckle up against the back
edge board, lower the hinge plate, and drive the screw.
Place the
approach plate assembly
(#3), with the large hinge
leafs (with five holes) on top of the board, with the downward facing
hinge knuckle up against the back edge of the board. Center the
width of the approach plate between the width of the assembled
section castings (approx 1/8” inside).
Drive the remaining
pan head wood screw
(#12 x 1”)
(#A) into
the approach plate.
Note: Apply small amount of wood glue to the screws.
STEP 2
STEP 4
STEP 3
STEP 5
SECTION WITH TOP APPROACH PLATE
3.
1.
1.
A.
3.
Knuckle
Leaf with four holes
Leaf with five holes
