BoardWalk Ramp and Platform Assembly Instructions
13
Identify the back edge of the section (the end with a socket -
opposite from the end with an arm).
Drive one
pan head wood screw
(#12 x 1”)
(#A) in the middle
hole on the left hinge. Push the right knuckle up against the back
edge board, lower the hinge plate, and drive the screw.
Place the
approach plate assembly
(#3), with the large hinge
leafs (with five holes) on top of the board, with the downward facing
hinge knuckle up against the back edge of the board. Centering the
width of the approach plate between the width of the assembled
section castings (approx 1/8” inside).
Drive the remaining
pan head wood screw (#12 x 1”)
(#A) into
the approach plate.
Note: Apply small amount of wood glue to the screws.
STEP 2
STEP 4
STEP 3
STEP 5
SECT. WITH BOTTOM APPROACH PLATE
1.
1.
3.
A.
A.
A.
