1
2
3
Installing the Printer and the intelligent Paper Stacker
1-23
1.10
Operating the intelligent Paper Stacker iPS 4050
Correct operation of the stacker is only ensured if the fold behind the first page
is positive i.e. the fold points towards the operator. If the fold is negative (it
points to the printer) the first page must be torn off.
Note:
The before mentioned procedure is only necessary for inserting new
paper (e.g. a new pile of paper or newly inserting the paper after paper
jam). See also chapter 1.9 Inserting Fanfold Paper on the previous
page.
1.10.1 Adjusting the Paper Exit Tray
To stack the paper precisely the intelligent Paper Stacker needs to be adjusted
to the paper length. This is done by means of the metal frame at the rear. To set
the paper length perform the following steps:
$
Loosen the two adjustment screws (1).
$
Move the frame (2) until the required length is visible on the ruler (3).
$
Tighten the adjustment screws (1).
Note:
The adjustment range for the paper length is from 7 inch up to 17 inch.