After removing the cutting blade assembly, locate the blade release at the top of
the cutting blade assembly and push it in (Figure 1). The blade will emerge from the
cutting blade assembly. You will need to gently pull the blade away from the magnet
holding it in place (Figure 2).
To install the new blade, let go of the blade release and carefully insert the shaft of the
blade into the hole in the bottom of the cutting blade assembly. The blade should be
“sucked” up inside the shaft if properly installed (Figure 3). The replacement cutting
blade is now installed. Reinstall the cutting blade assembly into the Cricut Expression
machine by reversing the procedure to remove the cutting blade assembly.
Figure 1
Figure 2
Figure 3
WARNING! Cutting blades are extremely sharp and should be handled with the
utmost care. They are also potential choking hazards; they should be kept away
from children.
Caring for the Cutting Mat
You can expect anywhere from 25–40 full mat cuts (expect even more when a cut is
smaller than the full mat) from your Cricut
®
cutting mat before it requires replacement.
Your actual cutting mat life will vary, depending on the settings you use and the pa-
pers you cut. When your paper no longer sticks to the cutting mat, it’s time to replace
the mat. Use only genuine Cricut
®
replacement cutting mats, available at retailers
everywhere.
TIP: To extend the overall life of each mat, use several mats, rotating them often, and
keep the original protective cover on your mat when not in use.
Cleaning Your Cricut Expression
®
Machine
WARNING! Always unplug your Cricut Expression
®
machine before cleaning!
To clean the Cricut Expression
®
machine, gently wipe exterior panels with a damp
cloth. Immediately dry any excess moisture with a chamois or other soft cloth.
Do not use chemicals or alcohol-based cleaners (including, but not limited to,
acetone, benzene, and carbon tetrachloride) on the machine. Abrasive cleansers
and cleaning tools should also be avoided. Do not immerse the machine or any
component of it in water.
Additional Basic Care Tips:
• Keep away from food and liquids
• Keep in dry, dust-free location
• Avoid excessive heat or cold
• Do not leave in car, where excessive heat may melt or damage plastic components
• Do not expose to direct sunlight for any extended period of time
22 ENGLISH
Downloaded from
www.Manualslib.com
manuals search engine
