RAIL
™
BOARD
SETTINGS AND FUNCTIONS
W
W
W
.
P
R
O
T
O
P
A
I
N
T
B
A
L
L
.
C
O
M
10
GREEN - Trigger Sensitivity
Values 1 - 20 (factory default 5)
Trigger sensitivity is the amount of time that the trigger has to be
released before the next trigger pull is allowed. In some situations
with too low of a value, the RAIL™ can register more trigger pulls
than what was actually pulled. This can cause the RAIL™ to shoot full
aauto, even in semi-automatic mode. To fix this, adjust the trigger
sensitivity setting higher.
RED - Dwell
Values 1 - 50 (factory default 40)
Dwell is the amount of time that the solenoid will be activated.
Follow these steps for the best way to set your dwell:
• Remove loader and any paintballs from the RAIL™ marker.
• With the dwell set at 30, start increasing the value until the marker
begins to fire.
• When you reach the setting where the marker begins to fire, get
some paint and a loader and go to a chronograph.
• Increase the dwell until you see no increase in the velocity.
This is the optimal dwell setting to be used.
NOTE: You cannot turn your marker off with the power button
when the marker is in configuration mode. You must first set DIP
switch 2 to the OFF position.
