VELOCITY ADJUSTMENT
The velocity of the RAIL™ is adjusted by adjusting the input
pressure into the RAIL™. This is controlled with the Hyper3™
regulator. The Hyper3™ on the RAIL™ is factory set to 150 psi which
will give you a velocity of about 285 FPS (Feet per Second).
A 3⁄16” allen key will be needed for this operation. Turning the
adjustment screw in (clockwise) will decrease the pressure, and out
(counterclockwise) will increase the pressure. To adjust the
velocity:
1. Make sure you and everybody around you is wearing ASTM/CE
approved paintball goggles.
2. Shoot the RAIL™ over a paintball chronograph.
3. To lower the velocity turn the Hyper3™ adjustment screw in. To
increase the velocity turn the screw out. Only turn the screw a
quarter turn at a time and shoot over the chronograph again.
Notice that a few shots are needed before the change can be
seen on the chronograph.
MAINTENANCE
For the RAIL™ to function properly, it is essential that the input
pressure into the marker stays consistent at all times. The general
maintenance needed for the Hyper3™ regulator is to keep it clean
of dirt and debris at all times. A more extensive service should be
performed every 12 months by a trained Tech or if the output
pressure of the regulator becomes inconsistent. This can be seen
as inconsistent velocity and verified with a regulator tester (sold
separately). Notice that the Hyper3™ has a break in period of
about 2000 shots before it achieves the best performance.
HYPER3™ IN-LINE REGULATOR
ADJUSTMENTS AND MAINTENANCE
W
W
W
.
P
R
O
T
O
P
A
I
N
T
B
A
L
L
.
C
O
M
20
