PRONAR VMP-10, Руководство пользователя, Страница: 45 / 78

4.7
foodstuffs depends not only on worm speed but also on position of cutting blades and its
wear as well as on time of mixing and milling.
ATTENTION
It is strictly forbidden to stand on the platform or in close vicinity of the tank during
loading procedure. Staying on the platform is allowed only when a bulk of foodstuff is
initially crushed and mixed.
Taking a place over the upper edge of added top wall when power take-off shaft is in
operation is strictly forbidden.
When loading the draught bar may raise slightly due to temporary load. For that reason it
is essential to connect and secure the string properly.
If there is a necessity to stand on the platform when the worm is in operation, one must
mind the dust coming out of the tank and protect one’s eyes.
During worm operation – during milling and mixing procedure, it is forbidden to dip into
the tank using hands or other objects.
In the first place one should administer foodstuffs that require fine milling (hay, straw, fresh
grass). It is necessary to use weight when loading bulks of foodstuffs. Hay and straw may
rotate along with the worm, thus it is essential to adjust milling blades so that the mixing and
cutting process was running through properly. Another component may be administered
when the first bulk is properly mixed and milled.
CAUTION
Milling blades adjusting procedure may only be performed with the worm drive powered
off.
Next, one ought to administer heavier components, such as silage and hay, potatoes, beet
pulp, mangold, etc. Milling and mixing process ought to run until obtaining homogenous
animal feed.
The last stage consists in adding the lightest components, of low graininess or liquid
components (cereals, flour, foodstuffs, water, etc.).