PRONAR PRONAR 5110, Руководство оператора

Страница: 82 / 122

Section 5: USING THE TRACTOR
5-34
RUNNING IN TRACTOR
ATTENTION: The first 50 mth of tractor work have a significant influence on tractor life
and especially on the engine.
A new tractor, at the beginning of the working period should be run in for a period of not less than 50 hours.
During running in time it is important:
•
Not to allow engine overheating;
•
Not to allow overloading of engine. Work in high gears under great load may cause overloading of
engine. This results in engine's unresponsiveness to increased RPM.
•
Do not allow engine to work without load. It may have the same negative effect on engine as
overloading. Change type of work undertaken so that engine is used in conditions of great and small loads.
•
Carefully watch appliance indicators and controls;
•
Stop work of tractor and contact service at whatever sign of incorrect operation of engine or tractor.
In addition to normal maintenance during the running in period also check every 10 hours the levels of liquids
and oils in gearbox and rear axle, hydraulic systems, forward drive axle and engine. Check the tightness of
bolts securing wheels to wheel hubs.
After the running in period, conduct service inspection after 50 hours (at manufacturer's authorised service)
in the extent given in table "TABLE OF TECHNICAL SERVICE INSPECTIONS”. Method of performing all
specified functions is described in Section 6 "MAINTENANCE”.
Service inspection after running in is performed at purchaser's cost.
TOWING TRACTOR
For towing tractor use the towing drawbar pin in front weights. If possible, use towing shaft or
chains to the tractor. In the event of using chain avoid sudden manoeuvres. Observe the local rules
referring to towing.
DANGER: Do not use rope or string to tow the tractor In the event of breaking, rope or
string may strike with sufficient force to cause physical injury.
ATTENTION: When towing the tractor, set all levers and gears to neutral position. Gear
reduction lever should be in "HARE” position. Otherwise gear assembly may be
damaged during towing.