PRONAR PRONAR 5110, Руководство оператора

Страница: 45 / 122

Section 4: STEERING AND OPERATING CONTROLS
4-23
Figure 4-30 PTO switch on tractor rear right mudguard.
PTO switch placed externally on the left mudguard serves only for momentary connection of PTO
(e.g. in joining up machines).
ATTENTION: Operator may only use external PTO switch standing to the side of the tractor.
To avoid damaging machine or tractor do not use simultaneously control system in the cab
and outside the tractor.
To start rear PTO using a button on mudguard it is necessary first to press the black button in the
PTO switch 1
(Figure 4-29
) placed in cab (only press the button without pulling the yellow
mushroom part upward). Next press and hold the green button on the mudguard (Figure 4-30). PTO
shaft shall rotate while operator holds the button.
DANGER: Before using the external PTO switch, make certain that there is nobody and
nothing near the machine or PTO shaft.
Never engage PTO standing:
- directly behind the tractor or wheel
- between lower link arms
- on machine or beside it.
When engaging PTO, never put hand or leg or any other part of the body close to three-
point linkage, PTO or machine.
SELECTION OF DEPENDENT-INDEPENDENT PTO ROTATION
Choice of type of dependent-independent rotations shall be made with disengaged PTO
drive.
Figure 4-31 PTO control lever (switchover to
revolutions: dependent –
independent) and pictogram
1 - lever engaging dependent-independent
revolutions;
Engaging the appropriate speed of PTO revolutions requires adherence to the following action
sequence:
•
for dependent speeds:
- pressing clutch pedal;
- starting engine with minimal revolutions speed;
- setting of lever 1 (Figure 4-31) forwards according to direction of tractor travel;
- smoothly releasing pressure on clutch pedal;
1