PRONAR PRONAR 5110, Руководство оператора

Страница: 81 / 122

Section 5: USING THE TRACTOR
5-33
OPENING ENGINE BONNET
The bonnet is secured with hinges in front of front windscreen to ensure easy access to engine in
order to conduct periodic service. Two compressed gas springs placed under bonnet facilitate lifting.
Figure 5-41 Bonnet and engine side covers. 1 - engine bonnet; 2 - side cover; 3 - snap fasteners securing
side cover; 4 - bonnet lock release pull rod
To raise the engine bonnet 1 (fig. E-35) proceed as follows:
•
to pull release ring 4 to open bonnet catch;
•
raise bonnet 1 upwards so it is held in position by compressed gas;
•
if necessary remove side covers 2 pull out snap fastener 3 securing side covers on right and left side of
engine (if present);
To close engine bonnet lower it energetically. Bonnet catch should snap shut.
ATTENTION: In the event of high temperatures, engine side covers should be removed
from tractors equipped with them.
WASHING TRACTOR
PRONAR 7150 tractors are modern machines with a large number of electrical sub-assemblies,
which are sensitive to water. This should be remembered while washing tractor, especially when using high-
pressure washing equipment.
Tractor may be washed with water with addition of commercially available car washing agents.
Before washing, first protect battery, starter motor, alternator, exhaust pipe, air filter and sensors. During
washing remove dirt from surface of tractor assemblies.
When washing with pressure washer jet do not stand too close to the tractor and avoid directing
stream of water at electronic or electrical subassemblies, electrical connections and air bleeders.
ATTENTION: Never direct stream of cold water on the hot engine or exhaust system.
4
2
3
3
1