ProMinent ProMaqua Dulcodes A, Руководство по сборке и эксплуатации

Страница: 65 / 120

1. Switch off the UV system using [F1]
2. Close the shut-off valves upstream and downstream of the
radiation chamber
3. Switch off the main switch or disconnect from the mains
power supply
4. Drain the radiation chamber
5. Depending on the system size, now first remove the wiper
motor
6. Remove the safety switch of the UV lamp cover
7. Loosen the fixing bolts of the UV lamp cover using an Allen
key and remove the UV lamp cover and the UV lamp
8. Lay the UV lamp cover and the UV lamp completely to one
side
9. Loosen the UV lamp protection tube bracket with a face
spanner and remove it (place on the holes, not on the
threads!)
10. Carefully remove the UV lamp protection tube completely out
of the radiation chamber and place on a suitable clean sur‐
face
11. Remove the O-Ring from the UV lamp protection tube
12. Wash the UV lamp protection tube with cleaning solution or
immerse it in cleaning solution until the film has been
removed without leaving a trace
13. Rinse the UV lamp protection tube with clean water and dry
thoroughly with a soft cloth
14. Carefully push the UV lamp protection tube into the radiation
chamber until it reaches its stop position
15.
CAUTION!
Check the UV lamp protection tube for
damage before fitting
– Do not refit a damaged UV lamp protec‐
tion tube
– Ensure that the lamp protection tube is
sitting correctly
– Do not allow the UV lamp protection
tube to project by more than 13 mm
and sit at an angle
Push a new O-ring onto the end of the UV lamp protection
tube.
Condition of the O-ring
Check whether the O-ring on the UV lamp
protection tube bracket is seated in the
groove provided. The sealing surfaces on
which the O-ring sits should be completely
smooth and clean.
16. Screw the UV lamp protection tube bracket into the chamber
cover until hand-tight.
Cleaning after dismantling the UV
lamp protection tube
Maintenance
65