6/ LOADING OF VINYL
1
2
– Place the plotter on a flat and stable area or on its stand
Place the roll on the roll holder fixing it with disks:
–
6
–
:
Close down the rollers by raising the levers located at the back
4
5
–
– Attention: the pinch rollers should be always placed above the scratched parts of the
driving roll to allow the proper holding of vinyl:
Put the vinyl on the roll holder and load the vinyl from the back of the plotter and place
it as straight as possible to avoid any movement
Raise to close
down rollers
Lower to
raise rollers
5
– Place the pinch rollers at the left and right ends side of vinyl by leaving approximately
1 cm of margin outside the rollers like below:
YES
NO
08
PROMACUT PC-730E
[email protected] - www.promattex-international.com
Address: 7 bis impasse Denis Dulac, 94700 MAISONS-ALFORT, FRANCE
Phone: 00 33 141 79 00 45 - Fax : 00 33 143 53 93 57
