Mototronik 21
11.6 Stand
(
1
) To remove the stand, take hold of it and press the button
A
, then swing the stand down until it detaches from the motor unit (
3
).
(
4
) To insert the stand, take hold of it and get it close to the motor unit. Then insert the axle
B
into the slot
C
(
5
) and swing it up until it locks in the housing
D
(
6
).
Check that the lower side of the stand folds towards the motor unit (
7
). If it folds towards the other direction (
8
), remove it, and remount it correctly.
To check the stand is securely locked, take hold of it and, without pressing the button, try to swing it down: it must not detach.
Before leaning the motor unit with the stand to the ground, make sure the stand is
correctly mounted and locked. The lower side of the stand must fold towards the
motor unit; otherwise, the motor unit will fall to the ground. Furthermore, in the
wrong position, the stand may impede the motor unit from coupling with the
connection frame.
Always be careful when resting the motor unit with the stand on the ground.
Uneven terrain (e.g., with holes) or sharp manoeuvring (e.g., fast handlebar
rotation) could cause the motor unit to fall.
Rehateam s.r.l. cannot be held responsible for damages due to non-compliance with these warnings.
1 2 3
A
A
4 5 6 7 8
B C
D
B
C
B
