Mototronik 13
10.2 Fitting and removing the battery
In the upper left side of the battery, you will find the key
A
that controls the lock pin
B
that lies on the rear side where you also find 6 coupling teeth
C
and the electric connector
D
.
You need to insert the battery and hook it to the battery support
E
on the motor unit.
To hook the battery, it is necessary that the pin does not stick out, in the "free" position
.
Should it stick out, in the lock position , you will not be able to insert the battery. To pull the pin in, turn the key by 180°.
(
1
) take hold of the battery and align the 6 coupling teeth with the notches
F
on the battery support, lean and slide the battery down. The electric connector will insert into the 4 pins
G
.
Turn the key to lock the battery (the lock pin will stick out and it will insert into the hole
H
of the support.
(
2
) to remove the battery, insert and turn the key, take hold of the battery and slide it upward.
Before each MOTOTRONIK driving session, make sure the battery is locked to
the support, then remove the key and store it in a safe space.
If the battery is not locked by means of the locking pin, it may detach and fall to
the ground while driving.
With the battery properly locked, but with the key inserted, it is possible, while
driving, that the key rotates to the extent that it unlocks the battery.
Never drive the device with the key inserted in the battery.
C C
C C
B D
B
B
A
E
F F
H
G
1
2
