REHATEAM s.r.l.—vicolo Negrelli
5
—
31040
Castagnole di Paese TV
-
www.rehateamprogeo.com
Service Manual JOKER JUNIOR 2.0 18
SERVICE MANUAL
REMOVABLE ARMREST
At each adjustment, spread some mild
lock thread glue on the bolts
H
and
V
.
V
H
A
H
C V
Advice for drilling.
While drilling a hole, such hole may result slightly moved with respect to the precise point you marked. For the first hole,
that move does not cause any trouble. On the other hand, for the second and third hole, it may cause a non-alignment between hole on the
side guard and hole on the blade. A good method to be more precise, once you reach point 5, is to use a 4 mm drill pin (in order to avoid
damaging the thread of the hole on the blade) and drill the side guard. Then, use and let a M5 tap through the threaded hole of the blade
and out of the side guard.
PAD POSITIONING:
you can fix the pad
I
of the armrest in three different positions
with respect to the tube of the blade. Such tube has, in fact, three pairs of holes.
Just remove the two bolts
H
, move the pad to either one of the other two position and
fix it again with the two bolts.
BLADE ORIENTATION:
you can assemble the armrest with blade
A
facing frontward or backward.
the difference between the two positions is approx. 3 cm.
To change the orientation of the blade, remove the armrest.
Screw off the two bolts
V
and remove the side guard.
Screw off the two bolts
H
and remove the pad
I
.
Reverse the pad and fix it to the tube with the two bolts.
Insert the armrest into the opposite support; right side become left.
No need to work on the bolt
C
.
Position the side guard and, through one of its two existing holes fix it to the blade
A
with one bolt (the second hole is hardly useable).
Mark and then drill the second hole on the side guard following the same instructions for the side guard modification.
Repeat the same operation for the other armrest.
H H
I