7
8. KEYPAD BEZEL - The keypad bezel is a screwless trim plate made of a pliable material that
conforms to the surrounding wall contour. The back of the bezel has form fitting tabs that
friction fit to The Source Keypad Mounting Bracket to provide a clean finished look.
THE SOURCE KEYPAD FEATURES
Figure 2
The Source Keypad Rear Panel
REAR PANEL
(Figure 2)
9. KEYPAD SET TABS - Fit into the upper Mounting Bracket Tab Slots to secure the keypad
to the bracket.
10. KEYPAD ANGLE TABS - Fits into the channeled lower Mounting Bracket Tab Slots to
allow flush installation (flat to wall surface) or with the lower portion of the keypad
sloping away from the wall at about a 15° angle. The angle mount creates a special
cosmetic appeal and provides an improved LCD viewing angle.
11. KEYPAD PUNCHDOWN BLOCK - 110 style punchdown terminal connects to the Zone
Keypad RJ45 jack on a Proficient M4 or M6.
12. SPEAKER RELAY MUTE TERMINAL - Connects to a Proficient Relay Muting Module for
individual room mute when using multi-channel amplifiers for subzone expansion.
13. ADDRESS SWITCH - Unique addresses are not required zone-to-zone (One keypad per
zone). However, a unique address must be set for each Source Keypad when connected on
a common bus within a single zone. The switch provides up to 16 addresses (0 to F). The
default address for the Source Keypad is “A”.
14. FACEPLATE RELEASE TABS - Carefully push these recessed tabs to remove the Source
Keypad faceplate to change keycaps. It is typically only necessary to press the tabs on
the bottom of the keypad and then carefully pull the bottom of the faceplate away
from The Source Keypad body.
IR
IR
+12
+12
GND
GND
485 A
485B
012
3
4
5
678
9A
B
C
D
EF
+ RELAY
- RELAY
9 12
11
9
12
10
14
14
13
IR
IR
+12
+12
GND
GND
485A
485B
Made in China
The Source Keypad
