Jetzt Angebot anfordern auf www.poolseller.de
»
NOTICE DE MONTAGE
/ OCTO & OCTO +
48
>>
ASSEMBLY OF THE OCTO POOL STRUCTURE (contd.)
The wooden brackets will support the coping that will be
mounted after the pool is filled. Pre-drill the wall from
inside the pool then attach each wooden bracket (type l)
using 2 screws (5x100mm sachet l) taking care to position
them 3mm below the top of the structure. Remove any
splinters that may have been raised during this process.
The are 3 wooden brackets per side (except the side
holding the skimmer). Position 1 wooden bracket in the
centre of the slat, the other 2 equidistant on either side of
it (D2 in the table).
Mount 2 wooden brackets on the wall holding the
skimmer, they should be positioned 75.5 cm apart and
equidistant from the skimmer axis.
Mount an anchoring plate (coping support bracket kit) on
each coping support bracket. Make sure that the top of
the plate is flush with the top of the walls.
IMPORTANT !
Check that the structure is correctly assembled
before mounting the liner locking track.
To do this:
- use a spirit level to check that the structure is
horizontal around the entire periphery.
- check that the 4 diagonals are equal in length.
Fix any imperfections before continuing.
The liner locking track should be flush with the top of
the wooden structure.
Before mounting the liner locking track, pre-drill using
a Ø 3mm drill bit.
Avoid over tightening, this could cause the screws to
break through the track.
10
11
12
13
14
»
INSTALLATION INSTRUCTIONS
/ OCTO & OCTO +
Jetzt Angebot anfordern auf www.poolseller.de
