Jetzt Angebot anfordern auf www.poolseller.de
»
NOTICE DE MONTAGE
/ OCTO & OCTO +
60
>>
MOUNTING RIGID DESCENDING PIPES
63
64
65
66
67
68
Wrap Teflon 4 or 5 times around the
threading of the elbows on the rigid
descending pipes C&C’ that you will find
in the Accessories skin pack, then screw
them onto the outside of the throughwall
flanges (return fitting and vacuum point).
Don’t forget to use the o-rings provided in
the Pool Fittings skin pack.
Tighten by hand to avoid crushing the
seal.
Next, screw the upper barrel union
of the rigid descending pipe C onto the
elbow.
Screw the unions, J, under the
skimmers. Do not forget to wrap Teflon
around both threadings.
Screw the heads of the compression
fittings on under the skimmers. Cut the
pipes according to the marking that
corresponds to the height of the pool.
Chamfer the edge of the cut slightly to
facilitate insertion of the pipe into the
compression fitting. Check that the pipe is
fully inserted then tighten the green ring
to create a water tight seal.
Screw the rigid descending pipe C onto
the return elbow. Do not forget to check
that the o-rings are in place.
Cut the rigid descending pipe on the
vacuum point (as described previously
according to the height of your pool), and
mount it as shown in image 66.
Vacuum point rigid
fittings
Elbow on return
fitting throughwall
flange.
Union under the
skimmer
Rigid descending
pipe below the
skimmer
Return fitting rigid
descending pipe
Vacuum
fitting rigid
descending
pipe
»
INSTALLATION INSTRUCTIONS
/ OCTO & OCTO +
Jetzt Angebot anfordern auf www.poolseller.de