probst VM-301-KJ-GREENLINE, Руководство по эксплуатации

Страница: 55 / 79

8
5.2 CAN-MATRIX
For detailed information see attached CAN parameter list. Optional CAN configurations are
listed below
▪
CAN protocol CAN 2.0 A
▪
Baud rate of the CAN interface250k
▪
120 Ohm termination resistor integrated in termination
For smooth CAN communication, another 120 Ω
Terminating resistor required. Star taps should be avoided.
5.3 PIN ASSIGNMENT
DANGER
▪
Separation of power under load must be avoided to protect persons and components.
When changing the power cabling or pulling a plug, make sure that the system is
switched off.
WARNING
▪
The power must always be connected before communication.
▪
The communication plug must be disconnected before the power connection
▪
If changes are made to the power cabling, the system must be switched off.
5.3.1 Power connector
Designation Manufactu
rer
Battery page Opposite side
Peculiarity Connector
APP 940-BK, SB175A, grey 940-BK, SB175A, grey
Service contact APP 1383-BK, PP180, AWG2 1383-BK, PP180, AWG2
Waterproof rubber
protection cap
APP
3-6036P1, Boot, Cover
Source
3-6037P1, boat, cover load
Table 5: Power connectors and accessories
5.3.2 Communication plug
Designation Manufactu
rer
Connector Battery side Connector opposite side
Drive communication connector Delphi 15326660 - f 15326661 - m
Communication connector
termination/parallel operation
Delphi 15326661 - m 15326660 - f
Communication connector Battery Bulgin PX0413/12S/PC PX0410/12P
Table 6: List of communication plugs
The power and communication plugs for the vehicle side are not included in the scope of
delivery. For additionally required contacts, the following table lists the manufacturer numbers
for the contacts.