probst VM-301-KJ-GREENLINE, Руководство по эксплуатации

Страница: 25 / 79

Operation 24 / 43
51500024 V2 GB
4.4 System start
Before the daily use, all daily checks must be done (see chapter "Daily checks").
The driver must sit in the driver's seat and the seat belt must be fastened.
•
Before the system (drive) is started, the handbrake ① must be
applied!
•
Insert the start key into the key switch ② (upper right dash board -
next to the display).
•
Turn start key to position I. To start the system, press and hold the
"Start" button next to the ignition lock ② for at least 2 seconds.
•
To stop the system, simply turn the start key to position 0.
•
The system switches off after approx. 10
minutes (power saving mode) if no machine
movements are performed within this time.
The start key can only be removed in position
0.
•
Press the reset button (button for horn) . The horn sounds once to
warn people in the vicinity that the machine is about to start driving.
Do not release the handbrake ① until the driver has taken a seat in the driver's seat. Press the handbrake
button to release the handbrake.
If the driver leaves the driver's seat, the parking brake must be applied again!
No travel movement can be carried out with the handbrake applied!
•
To stop the system, always set the start key to position 0!
The Reset button for travel and must be pressed each time
the installation machine is started or the travel has been
stopped due to the driver getting up from the driver's seat
(triggered by the seat switch).
The reset button (and driving the machine) only works
when the driver is in the driver's seat.
①
②