Pro-face PL-5900 Series, Руководство пользователя

Страница: 98 / 145

Chapter 6 - Setting Up Your PL OS
PL-5900 Series User Manual
6-19
2) Touch each point, in the order it appears.
• Do not touch both points simul-
taneously.
• Touch the panel exactly on the
lit up areas.
• The measured value is re-
displayed if you touch the
panel again.
The difference between the logic value and the
measured value is obtained.
To quit programming, press the [Esc]
key. Then, when the message shown on
the left appears, press the [Y] key. The
program will end without saving data.
Here, pressing the [N] key will return
you to the calibration mode.
3) Start up the “Test Mode” with the [
↵ ↵↵ ↵↵
] key.
This mode tests the calibrated value to deter-
mine if it is correct or not.
The perimeter is OK if it is drawn along the path
you traced by finger. Otherwise, return to the
“Calibration Mode” and touch the lit up areas
again.
You can return to the “Calibration
Mode” with the [Esc] key.
4) If test results are OK, press the [Enter] key.
When the message shown at the left appears,
input the data file name and press the [
↵
] key.
When specifying the data file name for
the parameter (-C=[path name]) at the
CALIB59.EXE start-up, the program
ends without displaying the message
shown on the left.
Terminate program without saving calibration data?(Y/N)
Analog Touch Panel Calibration CALIB59.EXE Version
X.XX
Copyright (c) 2000 Digital Electronics Corporation
Calibration Mode
Touch upper left and lower right corner of the screen.
[Enter : Go to test mode.
[Esc] : Terminate program.
Upper left Lower right
(0039.0026) (0997.0988)
The measured value is
displayed on the screen.
Analog Touch Panel Calibration CALIB59.EXE Version X.XX
Copyright (c) 199X Digital Electronics Corporation
Test Mode
[Enter] : Save calibration data and Exit.
[Esc] : Return to calibration mode.
Calibration data name? ATPH59.CAL_