Pro-face PL-5900 Series, Руководство пользователя

Страница: 68 / 145

Chapter 5 - System Setup
5-11
PL-5900 Series User Manual
Onboard FDC Controller Enabled
COM Port 1 3F8/IRQ4
COM Port 4 2E8/IRQ10
UART Mode Select Normal
x UR2 Duplex Mode Half
Onboard Parallel Port 3BC/IRQ7
Parallel Port Mode SPP
x ECP Mode Use DMA 3
COM Port 2 2F8
COM Port 2 Use IRQ IRQ3
COM Port 3 3E8
COM Port 3 Use IRQ IRQ11
↑↓→← :
Move Enter:/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Previous Values F6:Fail-Safe Defaults F7:Optimized Defaults
CMOS Setup Utility - Copyright (C) 1984-2000 Award Software
SuperIO Device
Item Help
Menu Level
Select Super I0 Device from the Integrated Peripherals menu and the following
screen will appear.
5.2.6 Super I0 Device
„ „ „ „ „
Onboard FDC Controller
This setting enables or disables the onboard floppy disk controller. The available
settings are [Disabled] and [Enabled]. The factory default setting is [Enabled] and
is recommended for most users.
„ „
„ „ „
COM Port 1
This setting determines the port address and the interrupt request number used by
the onboard serial port 1. The available settings are [Disabled], [3F8/IRQ4], [2F8/
IRQ3], [3E8/IRQ11], [2E8/IRQ10] and [Auto]. The factory default setting is
[3F8/IRQ4] and is recommended for most users.
„ „ „ „ „
COM Port 4
This setting determines the port address and the interrupt request number used by
the onboard serial port connected to the touch panel inside the PL. The available
settings are [Disabled], [3F8/IRQ4], [2F8/IRQ3], [3E8/IRQ11], [2E8/IRQ10] and
[Auto]. The factory default setting is [2E8/IRQ10] and is recommended for most
users
„ „
„ „ „
UART Mode Select
This setting determines the operation mode of the onboard serial port 2. The
available settings are [Normal], [IrDA], [ASKIR] and [SCR]. The factory default
setting is [Normal] and is recommended for most users.
„ „ „ „ „
UR2 Duplex Mode
This setting determines the communication mode when serial port 2 is set to
[IrDA] or [ASKIR] mode in [UART Mode Select]. The available settings are
[Full] and [Half]. The factory default setting is [Half].