Pro-Fab Industries Empyre Elite XT, Инструкция по установке и эксплуатации

Страница: 32 / 32

Warranty service may only be performed by Pro-Fab Industries
or a Pro-Fab Authorized Empyre Elite XT Furnace Dealer or a
Pro-Fab Authorized Empyre Elite XT Furnace Service Centre.
PRO-FAB INDUSTRIES INC. WARRANTY
Pro-Fab Industries Inc. (hereinafter called “Pro-Fab”) warrants to
the original owner of the Empyre Elite XT Furnace (hereinafter
called the “Empyre Elite XT”) the following:
A two (2) year warranty on the workmanship of the furnace and
workmanship on all parts manufactured by Pro-Fab, from the
consumer date of purchase, and excluding normal wear items
such as (but not limited to) the door gasket, fire brick, insulation,
refractory, exterior finish.
A one (1) year warranty for any labour required for any repair or
replacement of the furnace or parts from the consumer date of
purchase based on Pro-Fab’s predetermined labour rates and
allowable hours.
A limited pro-rated warranty coverage (which includes the one
(1) year labour coverage at Pro-Fab rates and hours as stated
above) for a defective firebox and water jacket only, based on the
following pro-rated scale from the consumer date of purchase:
• Years one (1) and two (2) – one hundred percent (100%)
coverage;
• Years three (3), four (4) and five (5) – sixty percent (60%)
coverage;
• Years six (6) and seven (7) – thirty percent (30%) coverage;
• Years eight (8) and nine (9) – fifteen percent (15%) coverage;
• Year ten (10) – ten percent (10%) coverage.
Absolutely no warranty is provided after ten (10) years from the
consumer date of purchase.
Note: All parts NOT manufactured by Pro-Fab carry their own
manufacturer’s warranty. The owner is responsible for all related
costs necessary to replace those parts, unless covered by the
applicable manufacturer.
The above warranties are based on the following factors:
Pro-Fab reserves the right to repair or replace at its discretion
any defective part or furnace, in whole or in part.
Use of Pro-Fab approved water treatment. IMPORTANT: Pro-
Fab approved water treatment is available from your local dealer
or service centre and must be used and validated for warranty
coverage. The pH balance must remain between 8.8 and 11.0, the
nitrite level must remain between 730 and 1460 ppm as NaNO2,
and conductivity must be less than or equal to 4000 mmhos. A
copy of the invoice itemizing the purchase of approved water
treatment will be required as proof of maintenance in the event
of a warranty claim. All laboratory reports must be kept as proof
of maintenance as indicated in the Installation and Operation
Instruction Manual.
All instructions within the Installation and Operation Manual, as
well as all local/provincial/state and national codes have been
adhered to with respect to the chimney size and installation.
The water temperature has not dropped below 165°F (74°C)
during operation.
All instructions within the Installation and Operation Manual, as
well as all local/provincial/state and national codes have been
adhered to with respect to the minimum clearance to combustibles
and use of a non-combustible liner on a combustible floor for an
indoor installation, per the guidelines within this manual.
All instructions in the Empyre Elite XT Installation and Operation
Instruction Manual have been followed.
The Warranty Registration and a copy of the original bill (invoice)
must be forwarded to Pro-Fab within thirty (30) days of the date
of purchase to validate the warranty.
Issue Date: February 2013 Part No. 817969R01 Printed in Canada DG0213
10 yEar lImItEd Warranty
Pro-Fab will not be responsible or liable for any of the follow-
ing: a) If warranty work requires removal or replacement of all
or a part of the furnace, Pro-Fab is not responsible for the cost
of plumbing, freight, permits, removal or disposal of damaged
furnace or parts, replacement of water or additives, labour after
the one (1) year warranty coverage expires, or any cost other
than the warrantied replacement part itself or the furnace; b)
The care, maintenance and safe operation of the Empyre Elite
XT Furnace which is the responsibility of the owner of the fur-
nace; c) Any accidents, injury, damage or loss incurred due
to a heating system failure; d) Any accidents, injury, damage
or loss incurred due to faulty installation, operation or mainte-
nance; e) Any cost incurred for replacing or repairing of parts
not manufactured by Pro-Fab which carry their own manu-
facturer’s warranty; f) Any out-of-pocket expenses, alternative
accommodations or loss of revenue due to defective parts or
furnace; g) Performance problems caused by improper sizing
of the furnace, vent connection, or air openings; h) Damages,
malfunctions or failures resulting from the use of any attach-
ment not authorized by Pro-Fab; i) Units installed outside the
continental United States, Alaska, or Canada without prior ap-
proval from Pro-Fab; j) Units with their safety certification labels
removed; or k) Damages, malfunctions or failures caused by
force majeure, abuse, accident, fire, or acts of God.
Any available warranty will be void if: a) Maintenance pro-
cedures are not followed as indicated in the Installation and
Operation Instruction Manual; b) Water treatment and proper
additives are not used as specified in the Installation and Op-
eration Instruction Manual; c) The Empyre Elite XT Furnace has
been altered in any way; d) Any material other than Pro-Fab
approved fuel has been used; e) Any instruction given in the In-
stallation and Operation Instruction Manual which has not been
followed including during installation or regular maintenance;
or f) Any claim made under the warranty for a person other than
the original owner.
There are no other warranties, expressed or implied, by Pro-
Fab or its Authorized Empyre Elite XT Furnace Dealers or Au-
thorized Empyre Elite XT Furnace Service Centres regarding
the Empyre Elite XT Furnace except the warranty expressed
herein. ANY IMPLIED WARRANTIES, INCLUDING MERCHANT-
ABILITY, OR FITNESS FOR A PARTICULAR PURPOSE, SHALL
NOT EXTEND BEYOND THE APPLICABLE WARRANTY PERI-
ODS SPECIFIED ABOVE. PRO-FAB’S SOLE LIABILITY, WITH
RESPECT TO ANY DEFECT, SHALL BE AS SET FORTH IN
THIS LIMITED WARRANTY, AND ANY CLAIMS FOR INCIDEN-
TAL OR CONSEQUENTIAL DAMAGES ARE EXCLUDED.
No person is authorized to bind Pro-Fab to any other warranty
whatsoever. Pro-Fab reserves the right at any time to make chang-
es or improvements to the design, materials or specifications of
the Empyre Elite XT line of furnaces or parts without thereby be-
coming liable to make similar changes in the furnaces or any of its
parts previously manufactured.
Manufactured by:
Pro-Fab Industries Inc.
Box 112, Arborg, MB R0C 0A0
Empyre Elite XT
Model 100 and 200