Pro-Fab Industries Empyre Elite XT, Инструкция по установке и эксплуатации

Страница: 26 / 32

referenCe
24 EmpyrE ElItE Xt InstallatIOn and OpEratIOn manual
How to Correct a sticking Flapper
How to Check if the Flapper is sticking
1. If the fire burns well when loading door is open but
dies out when door is closed.
2. If little or no exhaust is present at the chimney when
blower is running. (Open rear door to ensure blower
is running.)
How to Correct a sticking Flapper
1. Check information to determine if the furnace is
being operated properly.
2. Shut off furnace.
3. Insert wire or hex saw blade through the blower
impellor towards blower exit. Insert wire through pin
hole on top surface of the blower, next to blower exit
mount.
Note: The flap opening and closing should be heard
when activated.
4. Turn furnace back on.
5. With blower on, carefully spray lubricant into the
blower for 5 seconds.
should the Flapper sticking problem persist:
1. Check if furnace is being operated properly.
2. Remove flapper unit, check to ensure the flap seals
in the closed position, clean and oil.
How to remove and reinstall
1. Disconnect power.
2. Remove blower bolt (use 5/16” socket with long
extension). Pull back on motor to remove.
3. Remove flapper (2 bolts - use 5/16” socket).
4. Inspect flapper. Upper tabs on flap must seat in
notches. When laying flat with flap closed, tabs must
not be higher than flush with frame surface. Check
with a straight edge; also check if flap in closed
position makes an air tight seal. Also check flap
opening setting, gap should be 3/8” (10 mm) for
the Empyre Elite XT 100 and 3/4” (19 mm) on the
Empyre Elite XT 200.
5. Generously apply oil to the flap on the sealing
surfaces.
6. To install make sure flap will not fall out of flapper
unit. If this is a problem simply apply tape at flap
tabs before installing.
7. Bolt the flapper unit into place, then bolt the blower
into place.
Empyre Elite XT 100 - Gap to be - 3/8” (10 mm)
Empyre Elite XT 200 - Gap to be - 3/4” (19 mm)
Flap tab and notch