Printronix P8000 Series, Руководство администратора

Страница: 321 / 422

Printing a Hex Dump
321
609:EXHAUST FAN
CHECK
(Cabinet model only)
Yes Sensor cannot detect current
in fan circuit. Power off the printer and remove
the paper path (see
Maintenance Manual). Check
that the fan cable connector is
connected. Check for
obstruction of vents and fan
airway, and remove any
obstructions. Check for items
beneath the printer blocking
cabinet vents. Power back on
the printer. If this message
appears again, contact your
authorized service
representative.
1
613: HAM. COIL BAD
#, #, #, ...etc No Hammer coil # failed current
test at power up. Contact your authorized service
representative.
1
614:HAMMER BANK*
NOT INSTALLED No Hammer Bank Not Installed.
Self-test routines do not
detect hammer coils at
printer start-up. Contact your authorized service
representative.
1
615:HAMMER FAN
CHECK Yes Sensor cannot detect current
in fan circuit. Check that fan cable is
connected. Check for
obstruction of vents and fan
airway; remove any
obstructions. Check for items
beneath the printer blocking
cabinet vents. Power back on
the printer. If this message
recurs, contact your authorized
service representative.
1
617:LOWER DRIVER
SHORT* No Lower Driver Short.
Circuit(s) on the hammer
bank or in the hammer bank
power cable shorted to
ground. Contact your authorized service
representative.
1
619:PAPER FEED
DRIVER CIRCUIT*
See Manual
No Paper Feed Driver Circuit.
The paper feed driver circuit
on the controller board is
drawing too much current. Contact your authorized service
representative.
1
620:POWER VOLT
CHECK* No Power Supply Voltage. The
power supply has failed. Replace power supply board.
622:SHUTTLE
DRIVER CRCUIT* No The shuttle driver circuit on
the controller board is
drawing too much current. Contact your authorized service
representative.
1
Table 2. LCD Message Troubleshooting Table (H-Series)
Displayed Message
Can User
Correct?
Explanation Solution
Fault Messages (H-Series with Numerical Prefix)