Printronix P8000 Series, Руководство администратора

Страница: 329 / 422

Printing a Hex Dump
329
<Online, etc...>
Half Speed Mode
No Status message: The
controller samples the
operating temperature of key
components of the print
mechanism. When higher
than normal temperatures
are sensed, the print speed
is automatically reduced by
50% and the message sent
the LCD. When the
components cool down, the
print speed returns to 100%
and the message clears. No action is required. If the
message appears often, contact
your authorized service
representative.
1
ILL NVM VALUE 5
ILL NVM VALUE 6
ILL NVM VALUE 7 Yes Illegal value was stored into
the Novram module. 1. Cycle power. Run the print
job again. If the message
appears, load the latest
emulation software.
2.
Cycle power. Run the print
job again. If the message
appears again, record the
exact display message,
follow the instructions on
page 296, “Diagnostics for
EXX, BAD NVM, or ILL
NVM Errors”, and contact
your authorized service
representative.
1
INITIALIZING... Yes This message indicates the
printer is beginning its
initialization process. No action is required.
INTAKE FAN CHECK Yes Sensors cannot detect
current in fan circuit. Cycle power. If the message
appears, press
CLEAR . If the
message does not clear, contact
your authorized service
representative.
1
INTERRUPT UNUSED
VECTOR 00 No The controller board
receives an interrupt it does
not understand. The problem
can be created by electrical
noise, by a software
problem, or by a hardware
problem. Cycle power. If this message
occurred once and never again,
you can ignore it. If the message
reappears or appears
consistently, contact your
authorized service
representative.
1
LOADING PROGRAM
FROM PORT XX% No Status message: the new
emulation program is loading
into printer RAM. XX%
indicates how much of the
program has loaded. No action is required.
Table 2. LCD Message Troubleshooting Table (H-Series)
Displayed Message
Can User
Correct?
Explanation Solution
Fault Messages (H-Series with Numerical Prefix)