Printronix L5520, Руководство пользователя

Страница: 114 / 246

Chapter 3
Loading Flash Memory
114
FILE SYS INVALID
OPTIMIZE&REBOOT The flash file system is either
invalid (corrupt) or not present.
The cause can be either a
program error or a hardware
failure of the DC flash memory. Reboot the printer
several times. If the
message persists,
replace the DC flash
memory on the
controller board, or
contact your service
provider.
FILE SYS WRITE
CHECK FLASH One or more errors occurred
while the printer was writing a
file into the flash file system.
The printer has marked the
corrupt file for deletion. The
cause can be data that became
corrupted during download, or a
hardware failure of the DC flash
memory.
NOTE: Although the corrupt file
cannot be used, it still
occupies space in the
flash file system. To
free this space,
optimize the flash file
system.
Optimize the flash file
system to delete any
marked files, then retry
the operation. (If you
were downloading
software, optimize the
flash file system, then
power off the printer and
download the software
again.)
If the message persists
after several tries,
contact your service
provider.
INSUFFICIENT RAM
REBOOT/ADD RAM Before the printer can write a
file into the flash file system, the
file must be completely stored
in the DC DRAM. In certain
situations, there might be
insufficient DRAM space for the
file, especially when the printer
has been operating for some
time. Reboot the printer to
clear the DC DRAM. If
the message persists,
contact your service
provider.
LOADING FONTS The printer is copying fonts
from DC flash memory to DC
DRAM. None.
Table 2. Flash Messages