Prince Castle DCFT-MCD Series, Руководство по обслуживанию

Страница: 55 / 66

Clean DCFT Release Sheets and Club &
Conveyor Belts
Daily PR34 D01
527-504revM_EN 55 Printed in USA 12/20 © 2020
Prince Castle DCFT
-MCD V
ertical T
oa
ster
Daily
PR34
D01
4
Remove wire bun chute and
clean.

Lift chute at an angle, lifting
rear of chute and then pulling
chute forward out of toaster.

Spray a clean, sanitizer-
soaked towel with Solidsense
APSC or McDonald’s DR
Concentrated Disinfectant
Cleaner.

Use the towel to clean the
wire bun chute.

Use the towel to clean all
exterior areas of the toaster.
Chemicals
Sanitizer solution, Detergent
solution or McDonald’s DR
Concentrated Disinfectant
Cleaner
5
Clean landing zone and
reinstall wire bun chute.

Spray a clean, sanitizer-
soaked towel with Solidsense
APSC or McDonald’s DR
Concentrate Disinfectant
Cleaner.

Use the towel to clean the
Pick-Up Zone.

Spray all areas of the Pick-Up
Zone with SolidSense
Sanitizer and allow to air dry.
Chemicals
Sanitizer solution, Detergent
solution or McDonald’s DR
Concentrated Disinfectant
Cleaner

Install wire bun chute by
sliding the wire bun chute over
the landing zone and into the
toaster.

Position the chute so that the
rear of the chute is secured by
2 posts at the rear of the
toaster.
NOTE: Front edge of the wire bun
chute should be positioned at the
edge of the toaster landing zone.
Proper installation of wire bun
chute is shown above right.
Improper installation of wire bun
chute is shown below right.