Primera CX1000, Руководство оператора

Страница: 22 / 54

18 Load Label Stock
7. Place an empty label core on the rewinder chuck. Push the core all the way back until it touches
the back label guide disc.
8. Place the outer label guide disc on to the rewinder chuck. Push the guide until it touches the
rewinder core. Turn the tension knob clockwise to secure the core and the label guide to the
chuck.
Note:
Some cores may be shorter than the the stock width. If so, make sure the distance between the label
guide discs is slightly larger than the stock width.
9. Print your label according to Section 5 of the manual.
Note:
Depending on when the printer was last used, the fuser will need to heat up or cool down before
the printer will print. This can take from 2 seconds to 2 minutes.
Figure 4-7.
Important Note: Use only
3" I.D. Cores!
Figure 4-8.
Important Note: Make
sure the dancer arm is in
the up position before
you start your print.