Port Forwarding
Network Setup -
After entering the correct TCP/IP settings you
will be ready for ‘Port Forwarding’ (Cases A, B).
Please record the TCP/IP settings of your IP Camera for future
reference. You may need this information to access your IP
Camera and to configure ‘Port Forwarding’.
1.
After clicking ‘Apply’ the system will prompt for a reboot.
Please allow the system 50 seconds to reboot and accept the
changes. After 50 seconds, close the configuration screen.
The view will display ‘Trying to Reconnect’. If the ACTIVE light
on the IP Camera has gone off and is now back on again
flashing, then the IP Camera has rebooted. After the system
reboots completely, remove the power supply from the
unit and close Internet Explorer.
Return your PC/Laptop TCP/IP properties to their original
settings.
Before installing the IP Camera, you must use ‘Port
Forwarding’ on your personal router (Cases A, B).
You will need to forward 5 ports:
t8FC1PSUZPVBTTJHOFEUPUIF*1$BNFSB
t$POUSPM1PSUZPVBTTJHOFEUPUIF*1$BNFSB
t7JEFP1PSUZPVBTTJHOFEUPUIF*1$BNFSB
t"VEJP5SBOTNJU1PSUZPVBTTJHOFEUPUIF*1$BNFSB
t"VEJP3FDFJWF1PSUZPVBTTJHOFEUPUIF*1$BNFSB
Both of these ports will be forwarded to the IP address you
assigned to the IP Camera.
In the example above, you would forward:
t
t
t
t
t
2.
3.
4.
IP Camera TCP/IP Settings
IP Address
Subnet Mask
Default Gateway
Preferred DNS Server
DDNS Server
8FC1PSU
Control Port
Video Port
Audio Transmit Port
Audio Receive Port
For information on how to use ‘Port Forwarding’ please read
Appendix C.
3
