Pride Mobility Go-Go Elite traveller, Руководство по техническому устранению неисправностей

Страница: 4 / 19

Go-Go Elite Traveller Plus Technical Troubleshooting Guide www.pridemobility.com 4
INTRODUCTION
GO-GO ELITE TRAVELLER PLUS TECHNICAL TROUBLESHOOTING
GUIDE
This Go-Go Elite Traveller Plus Technical Troubleshooting Guide covers diagnostic and repair scenarios for Go-Go Elite
Traveller Plus scooters that use the PG Drives S-Drive controller. The PG Drives S-Drive controller is a digital controller
that monitors the electrical system and emits beep codes when it encounters faults in the system.
This guide is divided into three sections:
!
Section 1 — Key Inserted Into Key Switch - No Signs of Power
!
Section 2 — Key Inserted Into Key Switch - Power On But Scooter Does Not Move
!
Section 3 — Beep Code Diagnosis
How to Use Pride Model Specific Technical Troubleshooting Guides
All new Pride Model Specific Technical Troubleshooting Guides follow the same format. They are divided into sections
addressing symptoms such as No Power or Unit Powers Up But Does Not Drive. If the mobility product is capable of
giving fault codes, one section will deal with each code for that model.
The troubleshooting guide utilizes diagrams that are located in the front and back of the guide. These diagrams identify
main components by number (1, 2, 3, etc.) and all connectors by number with a lower case extension (1a, 2a, 3a, etc.).
The diagrams also show how all of the components are connected.
Using the Table of Contents, locate the section that best describes your troubleshooting issue. Each section will include
a list of symptoms, followed by a diagnosis of the problem, and finally a solution or procedure to solve the problem. The
procedure is set up as a numbered list of instructions, which may include one or more tests. Results of these tests will:
!
Direct you to change a component and retest the system.
!
Go to the next numbered step.
!
Advance to a numbered step farther along in the section.
System Retest
When a procedure specifies to replace a component, you must retest the system after replacing the component.
To retest the system:
1. Remove the key.
2. Replace the component.
3. Reconnect any harnesses that were disconnected.
4. Reinstall the battery boxes.
5. Insert the key.
— If the scooter operates normally, then reassemble
the scooter.
— If another problem has surfaced, then go to that
procedure in this guide.
Figure 1. Diagram Insert
) (
(+)
2b
) (
50A
(+)