Model DB10L
Installation of 9-volt Alkaline Battery:
Your "Door Beacon" is powered by a 9 volt Battery (purchased separately). Use only Alkaline Battery.
The battery compartment is located in the bottom of the unit. To remove the cover, push in the direction of
the arrow. Connect 9-volt battery to the terminals. Position battery into the recessed compartment and
replace the cover.
To mount unit on the door:
Unit should be positioned on the inside of the door of the room you will be in.
An "Over the Door" Hanging Bracket is included that allows you to easily hang your "Door Beacon" on any
standard door. It also allows the convenience of moving the "Door Beacon" to a different door.
Insert Hanging Bracket from
bottom as shown.
Your "Door Beacon" can also be hung in place on the door by installing a screw where you want the unit
positioned. (Position high onto door at eye level) Hang the "Door Beacon" onto the screw by using the hole
on the molded bracket at the back of the unit.
To attach the "Door Beacon" to the door with the supplied Velcro, separate the two Velcro pieces by pulling
apart. Attach the thick, plush piece of the Velcro to the inside of the door after removing the paper backing.
Press the adhesive side firmly against the door. Secure the other section of Velcro to the back of the "Door
Beacon" unit, first removing the paper backing and then pressing the adhesive to the unit. The "Door
Beacon" can then be secured by pressing the Velcro on the unit against the Velcro on the door.
Attach Velcro on back as shown
