AdvAntAge - digitAl vAv diffusers
DISPLAY NAVIGATION
15
acutherm.com
|
ACUTHERM ADVANTAGE - Manual
service Menu
LCD Stats Only
The service menu allows the balancer/installer to access to the controller setup to change settings. For example setting flows,
heating outputs, etc.
Hold down
Menu
button for 5 seconds; display will show
‘Passcode:
’ Use the
Up
and
Down
buttons to enter the password in
this sequence:
Down, Up, Up, Down
BAlAnCing
Balancing
· Allows you to force damper open/close/min/max
· See page 16
vvt
vvt
· Allows you to set limits (%) in VVT mode
· See page 17
setPOint
setpoint
· Setup of Setpoint limits (day minimum/maximum)
· °F / °C selection
· See page 18
inPut
input
· Shows supply air temperature reading
· Shows if VAV and BACnet modules are attached
· See page 19
OutPut
Output
· Allows setup of Aux Binary, Analog outputs
· Allows setup of room light output (motion stat only)
· See page 20-21
BACnet
BACnet
· Allows setup of BACnet addresses
· MAC address, Device Instance Baud Rate
· See page 22
stAt setuP
stat setup
· Allows setup of LCD back lighting, sounds, motion sensor
· Adjustment of HVAC and room lighting timeouts
· See page 23
CO2 settings
CO2 settings
· Only available with LCD Tstat with CO2 and Humidity (See page 11)
Press Menu
tO eXit
exit –
This will exit the info menu if you select Yes
Note: Info menu will automatically time out after 60 seconds
