PREVOST X3-45 Multiplex, Руководство по обслуживанию

Страница: 773 / 1422

Section 14: STEERING
PA1562
13
3. Insert dipstick in reservoir. Remove it again to
check fluid level (Fig. 19).
4. Adjust level to "FULL" mark using proper
dipstick side depending on fluid temperature,
use
"Dexron-IIE or Dexron-III" automatic
transmission oil.
5. Reinsert and tighten the dipstick.
FIGURE 18: HYDRAULIC FLUID RESERVOIR LOCATION
14059
At regular intervals, fluid level should be checked
in the reservoir and filter assembly. Furthermore,
the oil filter cartridge element in the power
steering reservoir should be replaced every
50,000 miles (80 000 km) or once a year,
whichever comes first.
12.1.2 Filter Replacement
1. Unscrew and remove the cover nut located
on top of the power steering reservoir.
2. Remove the reservoir cover and the gasket.
3. Remove the retaining spring and finally the
filter cartridge element.
FIGURE 19: POWER STEERING FLUID RESERVOIR
14018A
12.2 STEERING STABILIZER CYLINDER
(DAMPER)
The steering damper is located on R.H. side, at
back of front axle (Fig. 20).
The cylinder is nonadjustable and non-repairable.
Check for oil leaks or lack of resistance.
Disconnect the cylinder from axle, then carefully
attempt to extend and collapse it manually.
The rod end (ball joint) is provided with a grease
fitting. Under normal conditions, it should be
serviced every 6,250 miles (10 000 km) or twice a
year, whichever comes first. Good quality lithium-
base grease NLGI No. 1 and 2 are recommended
(refer to section 24
"Lubrication") . Check the ball
joint for wear, and replace if necessary.
12.3 DRAG LINK
Lubricate the fittings every 6,250 miles (10 000
km) or twice a year, whichever comes first. Good
quality lithium-base grease NLGI No. 1 and 2 are
recommended (refer to section 24
"Lubrication") .