PREVOST X3-45 Multiplex, Руководство по обслуживанию

Страница: 1037 / 1422

Section 18: BODY
PA1562
19
button’s (4) sides to adjust the selected mirror
viewing angle.
Disassembly
At end of mirror arm, loosen the setscrews to
relieve tension on the ball stud. Remove the ball
stud. Remove the ball stud from the arm and
gently pull the harness out until the connector is
exposed.
Remove the four screws fastening the mirror
arm base to the coach. Slide the harness free of
the mirror arm base.
Assembly
Attach a stiff wire (snake) to the end of the
harness and insert the wire through the mirror
arm base and arm, gently pull the harness
through the arm and disconnect the "snake".
Connect the mirror head harness. Insert the
harness connector back into the mirror arm.
Insert the ball stud into the mirror arm and
tighten the socket setscrews.
NOTE
Position the ball cup halves so the joint
between them lies on the centerline of the
arm. Ensure that the setscrews are not on the
joint between the cup halves.
Convex & Flat Mirror Removal
The mirror glass assembly is mounted to the
control mechanism or to mirror base with Velcro
strips. Remove the mirror glass by gently pulling
the lens to release the Velcro. Disconnect the
heater grid at the two connectors.
Connect the connectors of the new mirror’s grid
to the harness. Install the lens by positioning the
lens in the mirror frame and pressing to lock the
Velcro in place.
7.5 WINDSHIELD WIPERS
Refer to Paragraph 23.8 Windshield Wipers and
Washers, included in Section 23: Accessories of
the Maintenance Manual for complete
information on windshield wipers.
7.6 WINDSHIELD
For the removal or installation of windshield, you
will need:
A rope,
A plastic spatula to lift the rubber seal lip,
A metal rod or screwdriver to clean the seal
groove,
A filler insertion tool,
Goggles and protective gloves.
•
From inside of vehicle, remove center post
and interior finishing panels surrounding the
windshield. In this case, we are replacing
the R.H. side windshield.
•
From outside of vehicle, remove filler
located inside rubber seal to ease damaged
windshield removal.
•
From inside of vehicle, push against the top
L.H. side corner of windshield for the re-
moval of a R.H. side windshield. If the L.H.
side windshield had to be removed, you
would have to push against the top R. H.
side corner.
NOTE
We are referring to the L.H and R.H. side as
viewed from the inside of the vehicle.
•
At the same time, another person gradually
lifts the rubber lip from the vehicle exterior
using a plastic spatula from top to bottom.
•
Remove the entire damaged windshield and
broken glass if applicable.
•
If applicable, using a screwdriver or metal
rod, remove black butyl sealant residue from
rubber seal then clean with Sika 205.
7.6.1 Windshield Installation
NOTE
Rubber seal may have to be replaced if it was
used on several windshield replacements.
•
Spray rubber seal with soapy water to ease
windshield insertion.
•
Insert rope into rubber extrusion leaving
enough length at each corner to make a
loop. Spray soapy water onto rope and
rubber extrusion (Fig. 7).
•
Slide windshield into rubber seal groove
starting with the bottom curved side edge.
Using a plastic spatula, move the rubber
seal lip aside to gradually insert the wind-
shield into the groove.
•
Spray soapy water on a regular basis to
ease this operation.