CONTROLS/INSTRUMENTS
2 - 15
• To stop seat movement, push any control
button (items 1 to 4).
Note:
The seat can, at any time, be positioned
using items 1,2 & 3 without affecting the two
memory positions.
Seat Belts
18028
Each seat is equipped with a retractable seat
belt as required by State, Provincial and Federal
regulations. To fasten, pull seat belt out of the
retractor and insert the latch plate into the buckle
until it clicks. No special adjustment is required
since the reel device is self-adjusting. If seat belt
operation becomes defective, report to Manu-
facturer's Service Center.
Note:
The seat belt must be pulled out slowly
and continuously, otherwise it will lock the reel
before the latch plate reaches the buckle. If this
happens, allow the belt to retract completely and
repeat the procedure correctly.
Warning:
A snug fit with the lap belt positioned
low on the hips is necessary to ensure motorist's
safety. Belt should not be worn twisted; avoid
pinching belt and/or belt hardware in seat
mechanism. Do not wear belt over rigid or
breakable objects, such as eyeglasses, pens, or
keys as these may cause injuries.
Caution:
Never bleach or dry clean safety belt.
To unfasten belt, press red button in center of
buckle and allow belt to retract. If belt does not
fully retract, pull it out and check for kinks or
twists. Make sure that it remains untwisted as it
retracts.
18029
Warning:
Seat belts should always be worn by
motorists using seats supplied with belts since
this is required by most State and Provincial
laws.
Automatic Transmission
The operation and driving of this vehicle with an
automatic transmission is similar to that of an
automobile equipped with an automatic trans-
mission. Proper ranges should be selected
according to driving speeds to improve vehicle
performance and control. The transmission is
fully automatic. Speed ratio of power converter
changes automatically as vehicle speed in-
creases and direct-drive goes in and out as
necessary, modulated by vehicle speed, and
accelerator position.
